7
7) Connect all the components together (electrically) and verify proper operation of
all the system functions.
a. The headrest DIN cables and the FMM Interface Box DIN cables are color
coded. Connect each headrest cable to the correct color cable on the FMM
Interface Box.
b. Extend the wireless FM antenna to its full length and orientate for best
reception. Do not place it on the FMM Interface Box or near metal.
c. Connect the DC power jack.
.
8) After verifying the proper operation of the system, mount each component.
9) When all the components are mounted, recheck the entire system to be sure it is
functioning correctly. Make sure that no wiring was pinched or connected
improperly during the final installation.
Wireless FM Modulator
The HR7011PKG is equipped with a built-in wireless FM Modulator*, that allows
you to listen to the DVD audio signal by tuning your vehicle’s radio to the selected
frequency, (
88.1MHz,
88.3MHz,
88.5MHz,
88.7MHz,
88.9MHz,
89.1MHz,
89.3MHz,
89.5MHz,
89.7MHz,
89.9MHZ,
90.1MHz,
90.3MHz,
90.5MHz,
90.7MHz,
90.9MHz,
91.1MHz). This feature is accessed by using the FM
transmitter buttons on the remote (FMM ON/OFF, Channel Select).
Whenever the FM Modulator is on, broadcast reception on the vehicle’s radio will
be poor. Switching off the FM Modulator will allow normal radio reception.
CH1
CH2
CH3
CH4
CH5
Ch6
Ch7
Ch8
Ch9
CH10
Ch11
CH12
Ch13
CH14
CH15
CH16
*Note:
Audiovox P/N
SIRSWB
In certain areas where there are a large number of FM radio stations (e.g. large
cities, urban areas), the reception of the FM signal may not be satisfactory, resulting in
static, distorted sound or signal bleed thru from strong local radio stations. This is not a
defect in the product, but the result of a stronger local radio station overpowering the
wireless FM transmitter in your overhead pod.
If wireless reception is unsatisfactory, an optional wired relay box (
) can be installed which will improve audio quality. Please contact the installer
if this is the case with your product.
