13
-
5
Inputs and outputs
Important
While connecting and removing sources, amplifiers or speakers to the HUM-
BOLDT, all units of your audio system have to be switched off to prevent
damage to the HUMBOLDT or any connected units.
Please make sure that all cables are in absolute best conditions! Broken shields
or short-cut cables could damage the HUMBOLDT and/or any other con-
nected unit.
5.1
Line level inputs
The HUMBOLDT is equipped with two balanced (XLR) '1' and '2' as well
as three Cinch (line) inputs '3' , '4' and '5' for connecting signal sources at
line level. Due to its double mono design, left and right channel input jacks are
separated on the back panel.
Please connect the left and right input of the same number printed on the back
panel of the HUMBOLDT to the corresponding output of the source which you
would like to connect to the HUMBOLDT.
5.2
Speaker terminals
Connect your speakers to the rhodium plated terminals SPEAKERS RIGHT and
SPEAKERS LEFT on the back panel of the HUMBOLDT. You may use banana
plugs or spades as well as simple cable ends. Fasten speaker terminals until the
torque stop clicks distinctly. The torque stop guarantees for the right fastening
torque at all times ensuring a safe contact.
