4
MIXER PROFESSIONALI
Serie
PAMX2
Left
Right
10
10
0
15
20
30
40
60
Mic 1
Bal
or
Unbal
LINE IN
Low Cut
75 Hz
18 dB/Oct
+10 - 40
+10
+60
TRIM dB/dBu
EQ
HIGH
12 KHz
MID
2.5 KHz
LOW
80 Hz
AUX
PRE
Mic 1
FX
PAN
MUTE
CLIP
SOLO
0
+15
- 15
0
+15
- 15
0
+15
- 15
-
¥
0
+ 15
0
-
¥
+ 15
1
MUTE
ALT 3-4
Fig 1
MONO CHANNELS
MIXER PROFESSIONALI
Serie
PAMX2
9
SCHEMA A BLOCCHI
1.
MIC: XLR balanced microphone input for dynamic and capacitor
microphones. By means of the XLR connector, it's possible to feed
condenser microphones. Operate button "PHANTOM ON" to activate this
function ( located on the rear panel) This function is monitored through the
red LED switch on + 48 V located over the LED level indicators. Use of
dynamic microphones with phantom power supply is generally not
recommended. *
2.
LINE: balanced or unbalanced line level input , 6,3 mm. Jack
connector.
Important: DON'T use MIC and LINE input signal at the same time
!!!! *
3.
This switch activates high-pass filter at 75 Hz - 18dB/Oct
4.
TRIM: To adjust channel input level.
Should always be completely turned counter clockwise during connection
of any source
5.
EQ HIGH: This control a/- 15 dB with a "shelving" curve
shape
at 12 kHz.
6.
EQ MID: This control adjusts +/- 15 dB with a band center at
2.5 kHz.
7.
EQ LOW: This control adjusts +/- 15 dB with a "shelving" curve
shape at 80 Hz.
8.
AUX: This control adjusts the output signal level
AUX SENDS 1, controlled through general adjustment (18). This signal is
normally "post" FADER but could become "pre" FADER by operating the
button (9)
9.
This button operates the pre/post FADER level of the AUX control
10.
FX: This control adjusts signal level to send to AUX SENDS 2 and
to DSP, controlled through general adjustment (19). This signal is always
"post" FADER
11.
PAN: It adjusts the stereo scene by adjusting the signal levels to
send to right and left outputs.
12.
MUTE: This dual-purpose switch turns off the channel and sends at
the same time a signal to an alternative mixing (ALT 3/4 ). Function is on
when yellow LED lights up.
13.
CLIP: The red LED is dual-purpose too: it indicates "SOLO"
function (See point 14) or indicates CLIPPING mode.
Important: in case LED lights up indicating clipping mode, operate by
reducing the TRIM
14.
SOLO: This button sends the signal to PHONES and CONTROL
ROOM OUT outlets and allows you to hear signals through your
headphones and view signal on LED level indicators. Operating the
"MODE" switch of the main section, it's possible to choose pre or post
FADER signal.
15.
FADER: It adjusts the level of the channel signal.
* See connection scheme on page 7
