Page 11 of 17
AudioCodes™ MP-100/104 Gateway Quick Start Installation Guide
March 2004
5.
Protocol Management:
Configure the Protocol Management field, as described below.
—
Control Protocol Type:
Should be set to
MGCP
.
—
Call Agent IP:
Should match the IPRC IP address.
NOTE:
If the MCGP gateway is behind a firewall or NAT, you must set the Call
Agent IP.
—
Call Agent Port:
Should be set to
2427
.
—
Call Agent Domain Name:
Leave this field blank.
—
Redundant Agent IP:
Should be set to
0.0.0.0
.
—
Redundant Agent Port:
Should be set to
2427
.
—
Redundant Call Agent Domain Name:
Leave this field blank. Inter-Tel does
not currently support this feature.
—
Communication Layer Timeout:
Should be set to
60
seconds.
— Packet Cable Support:
Should be set to
No
.
— Profile:
Should be set to
NORMAL
.
—
Gateway Name:
Enter the name to identify this gateway on the network, such
as MP104v4.2 (case-sensitive with no spaces or special characters).
NOTE:
With a v8.x firmware IPRC, ensure the names match those in Axxess
Database Programming (under System\Cabinets\IPRC (32-
Device)\Devices\MGCP Gateway and Endpoint).
—
Endpoint Name:
The default endpoint name is “ACgw” (case-sensitive) and
should not be changed to avoid hostname resolution complications. Each end-
point has a number appended to it. For example, line 1 is assigned the name
“ACgw0,” line 2 is “ACgw1,” and line 4 is “ACgw3.”
NOTE:
With a v1.x firmware IPRC, ensure the names match those on the
MGCP Endpoint Name Settings page in the IPRC Web page. With a v8.x firm-
ware IPRC, ensure the names match those in Axxess Database Programming
(under System\Cabinets\IPRC (32-Device)\Devices\MGCP Endpoint).
To apply the changes, click
SUBMIT
.