AudioCodes mediapack MP-500, User Manual

Page: 380 / 574

SIP User's Manual 380 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
(configured by the parameter HotLineToneDuration), the
destination phone number is automatically dialed.
ƒ
Module = Module number (where 1 depicts the module in Slot 1).
ƒ
Port = Port number (where 1 depicts the Port 1 of the module).
For example:
TargetOfChannel 0 = 1002,1,1,1; (phone number "1002" is automatically
dialed for Port 1 of Module 1)
TargetOfChannel 1 = 101,1,1,2; (phone number "101" is automatically
dialed for Port 2 of Module 1)
Notes:
ƒ
The indexing of this ini file table parameter starts at 0.
ƒ
Define this parameter for each device port that implements Automatic
Dialing.
ƒ
After a ring signal is detected on an 'Enabled' FXO port, the device
initiates a call to the destination number without seizing the line. The
line is seized only after the call is answered. After a ring signal is
detected on a 'Disabled' or 'Hotline' FXO port, the device seizes the
line.
ƒ
For configuring this table using the Web interface, refer to ''Configuring
Automatic Dialing'' on page
213 .
ƒ
For an explanation on using ini file table parameters, refer to ''Format of
ini File Table Parameters'' on page 273 .
6.8.11 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 6-40: DID Parameters
Parameter Description
Web/EMS: Enable DID
Wink
[EnableDIDWink]
Enables Direct Inward Dialing (DID) using Wink-Start signaling.
ƒ
[0] Disable = Disables DID Wink(default).
ƒ
[1] Enable = Enables DID Wink.
If enabled, the device can be used for connection to EIA/TIA-464B DID
Loop Start lines. Both FXO (detection) and FXS (generation) are
supported. An FXO interface dials DTMF digits after a Wink signal is
detected (instead of a Dial tone). An FXS interface generates the Wink
signal after the detection of off-hook (instead of playing a Dial tone).
Web/EMS: Delay Before
DID Wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between detection of off-hook and
generation of a DID Wink.
The valid range is 0 to 1,000. The default value is 0.
Note: This parameters is applicable only to FXS interfaces.