AudioCodes mediapack MP-500, User Manual

Page: 221 / 574

Version 5.8 221 October 2009
SIP User's Manual 3. Web-Based Management
3. Click the Submit button to save your changes.
4. To save the changes to the flash memory, refer to ''Saving Configuration'' on page
237 .
Table 3-29: Trunk Group Table Parameters
Parameter Description
Module
[TrunkGroup_Module]
The module type (i.e., FXS/FXO) for which you want to define
the Trunk Group.
From Trunk
[TrunkGroup_FirstTrunkId]
Not applicable.
To Trunk
[TrunkGroup_LastTrunkId]
Not applicable.
Channels
[TrunkGroup_FirstBChannel] ,
[TrunkGroup_LastBChannel]
The device's channels or ports. To enable channels, enter the
channel numbers. You can enter a range of channels by using
the format [n-m], where
n represents the lower channel
number and m the higher channel number. For example, [1-4]
specifies channels 1 through 4.
Phone Number
[TrunkGroup_FirstPhoneNumber]
The telephone number that is assigned to the channel. For a
range of channels, enter only the first telephone number.
Subsequent channels are assigned the next consecutive
telephone number. For example, if you enter 400 for channels
1 to 4, then channel 1 is assigned phone number 400, channel
2 is assigned phone number 401, and so on.
These numbers are also used for channel allocation for IP-to-
Tel calls if the Hunt Group’s ‘Channel Select Mode’ is set to
‘By Dest Phone Number’.
Note: If the this field includes alphabetical characters and the
phone number is defined for a range of channels (e.g., 1-4),
then the phone number must end with a number (e.g., 'user1').
Trunk Group ID
[TrunkGroup_TrunkGroupNum]
The Hunt Group ID (1-99) assigned to the corresponding
channels. The same Hunt Group ID can be assigned to more
than one group of channels. The Hunt Group ID is used to
define a group of common channel behavior that are used for
routing IP-to-Tel calls. If an IP-to-Tel call is assigned to a Hunt
Group, the IP call is routed to the channel(s) pertaining to that
Hunt Group ID.
Notes:
ƒ
Once you have defined a Hunt Group, you must configure
the parameter PSTNPrefix (IP to Hunt Group Routing
Table) to assign incoming IP calls to the appropriate Hunt
Group. If you do not configure this, calls cannot be
established.
ƒ
You can define the method for which new calls are
assigned to channels within the Hunt Groups, using the
parameter TrunkGroupSettings.
Tel Profile ID
[TrunkGroup_ProfileId]
The Tel Profile ID assigned to the channels pertaining to the
Hunt Group.
Note: For configuring Tel Profiles, refer to the parameter
TelProfile.