AudioCodes mediapack MP-500, User Manual

Page: 217 / 574

Version 5.8 217 October 2009
SIP User's Manual 3. Web-Based Management
Parameter Description
'Time for No Reply Forward' field.
ƒ
[5] Do Not Disturb = Immediately reject incoming calls.
Forward to Phone
Number The telephone number or URI (<number>@<IP address>) to where the
call is forwarded.
Note: If this field only contains a telephone number and a Proxy isn't
used, the 'forward to' phone number must be specified in the 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table'' on page
201 ).
Time for No Reply
Forward
If you have set the 'Forward Type' for this port to 'No Answer', enter the
number of seconds the device waits before forwarding the call to the
phone number specified.
3.4.5.11.5 Configuring Caller ID Permissions
The 'Caller ID Permissions' page allows you to enable or disable (per port) the Caller ID
generation (for FXS interfaces) and detection (for FXO interfaces). If a port isn't configured,
its Caller ID generation/detection are determined according to the global parameter
EnableCallerID described in ''Configuring Supplementary Services'' on page
170 .
Note: You can also configure the Caller ID Permissions table using the ini file table
parameter EnableCallerID.
¾
To configure Caller ID Permissions per port:
1. Open the 'Caller ID Permissions' page ( Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Caller ID Permissions page item).
Figure 3-171: Caller ID Permissions Page