AudioCodes mediapack MP-500, User Manual

Page: 104 / 574

SIP User's Manual 104 Document #: LTRT-12801
MP-500 MSBG
2. To add a new user, under the 'Users' group, click the New User link; the following
page appears:
Figure 3-86: Adding a New User
3. Under the General group, configure the following parameters:
a. Full Name: remote user's full name.
b. User Name: name that a user uses to access your network.
c. New Password: user's password.
d. Retype New Password: if a new password is assigned, type it again to verify its
correctness.
e. Primary Group: this check box only appears after a user is defined, enabling you
to assign the user to a primary group.
f. Permissions: select the 'Remote Access by VPN' check box to grant remote
access to the device using the VPN protocol.
4. Under the E-Mail Notification group, you can use e-mail notification to receive
indications of system events for a predefined severity classification. The available
types of events are 'System' or 'Security' events. The available severity of events are
'Error', 'Warning' and 'Information'. If the 'Information' level is selected, the user
receives notification of the 'Information', 'Warning' and 'Error' events. If the 'Warning'
level is selected, the user receives notification of the 'Warning' and 'Error' events, and
so on.
a. Ensure that you have configured an outgoing mail server. Click the Click here to
configure notification Mail Server link to configure the outgoing mail server (see
Step 5).
b. Notification Address: user's e-mail address.
c. Select the 'System' and 'Security' notification levels in the 'System Notify Level'
and 'Security Notify Level' drop-down lists respectively.