Configuration Note
12
Document #: LTRT-23304
Upgrading to Version 7.2
Following the upgrade, specific commands will be located in different paths. If management
software is used, for example a CWMP server, make sure that you have copied a Version
7.2.150 or later configuration file to the Management server. It is recommended to
download the new configuration to the Management Software after the MSBR have been
upgraded.
It is possible to manually download the configuration from the device using the copy
command. For example:
copy cli-script to tftp://10.51.13.5/config.cli
This command copies the configuration in the form of a CLI script (this is displayed when
the Show Run command is used) to the TFTP server address e.g. 10.51.13.5 to the file
config.cli. You can also use a FTP, HTTP, or HTTPS server for this command.
3.1
Single Network Mode
After you have upgraded, it is recommended to configure your device for the Single
Network mode. In this mode of operation, the Voice application runs on the MSBR as a
linked application, and therefore the network configuration is not required to be configured
on the Voice part. For more information about switching to Single Network mode, refer to
document
MSBR Simplifying Network CLI Configuration Note Ver. 7.2
.
Summary of Contents for Mediant MSBR
Page 2: ......