AudioCodes Mediant 500 MSBR, User Manual

Page: 943 / 1248

Version 7.2 943 Mediant 500 MSBR
User's Manual 63. Syslog and Debug Recording
2. Under the Activity Types to Report group, select the Web actions to report to the
Syslog server:
Figure 63-5: Configuring Web Activities to Report to Syslog
3. Click Apply .
Note:
•
You can also view logged user activities in the Web interface (see Viewing Web
User Activity Logs on page 853).
•
Logging of CLI commands can only be configured through CLI or ini file.
•
You can configure the device to send an SNMP trap each time a user performs a
Web activity. For more information, see Configuring SNMP Community Strings on
page 91.
63.2.6 Viewing Syslog Messages
You can receive and view Syslog messages generated by the device using any of the
following Syslog server types:

Wireshark: Third-party, network protocol analyzer (http://www.wireshark.org).
Note: When debug recording is enabled and Syslog messages are also included in
the debug recording, to view Syslog messages using Wireshark, you must install
AudioCodes' Wireshark plug-in (acsyslog.dll). Once the plug-in is installed, the Syslog
messages are decoded as "AC SYSLOG" and displayed using the "acsyslog" filter
(instead of the regular "syslog" filter). For more information on debug recording, see
Debug Recording on page 945.

Third-party, Syslog Server: Any third-party, Syslog server program that enables
filtering of messages according to parameters such as priority, IP sender address,
time, and date.

Device's CLI Console: The device sends error messages (e.g., Syslog messages) to
the CLI as well as to the configured destination. Use the following commands:
•
To start debug recording:
debug log