AudioCodes Mediant 500 MSBR, User Manual

Page: 938 / 1248

User's Manual 938 Document #: LTRT-10375
Mediant 500 MSBR
RD No Available Release Descriptor
RO RTP Reorder
RP Unknown RTP Payload Type
RS RTP SSRC Error
UF Unrecognized Fax Relay Command
AA Invalid Accumulated Packets Counter
AC Invalid Channel ID
AL Invalid Header Length
AO Invalid Codec Type
AP
Unknown Aggregation Payload Type
AR
Invalid Routing Flag Received
63.2.1.2 Unique Device Identification in Syslog Messages
Syslog messages include the following unique string for the device:

Syslog messages relating to VoIP functionality are marked with "host"; those relating
to Data Routing are marked with "DATA", for example:
12/12 12:46:40.921 : 10.8.5.70 : NOTICE : host: 10.8.5.78 (sip_stack)(24)
Resource SIPMessage deleted - #267
11/24 08:14:09.311 : 10.3.2.100 : WARNING : DATA: Failed to set device eth0
netmask: Cannot assign requested address

63.2.1.3 Identifying AudioCodes Syslog Messages using Facility Levels
The device’s Syslog messages can easily be identified and distinguished from Syslog
messages from other equipment, by setting its Facility level. The Facility levels of the
device's Syslog messages are numerically coded with decimal values. Facility level may
use any of the "local use" facilities (0 through 7), according to RFC 3164. Implementing
Facility levels is useful, for example, if you collect the device’s as well as other equipments’
Syslog messages on the same server. Therefore, in addition to filtering Syslog messages
by IP address, you can filter messages by Facility level.

To configure the Facility level:

Configure the SyslogFacility ini file parameter to one of the following options:
Table 63-5: Syslog Facility Levels
Numerical Value Facility Level
16 (default) local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)