AudioCodes Mediant 500 MSBR, User Manual

Page: 771 / 1248

Version 7.2 771 Mediant 500 MSBR
User's Manual 48. Auxiliary Files
48 Auxiliary Files
You can load the following Auxiliary files to the device.
Table 48-1: Auxiliary Files
File Description
INI Configures the device. The Web interface enables practically full device
provisioning. However, some features may only be configured by ini file or you
may wish to configure your device through ini file. For more information, see
INI File-Based Management on page 107.
CAS Contains CAS Protocol definitions for CAS-terminated trunks (for various
types of CAS signaling). You can use the supplied files or construct your own
files. Up to eight different CAS files can be installed on the device. For more
information, see CAS Files on page 778.
Call Progress
Tones Region-specific, telephone exchange-dependent file that contains the Call
Progress Tones (CPT) levels and frequencies for the device. The default CPT
file is U.S.A. For more information, see Call Progress Tones File on page 773.
Prerecorded
Tones The Prerecorded Tones (PRT) file enhances the device's capabilities of
playing a wide range of telephone exchange tones that cannot be defined in
the CPT file. For more information, see Prerecorded Tones File on page 778.
Dial Plan Provides dialing plans, for example, to know when to stop collecting dialed
digits and start forwarding them or for obtaining the destination IP address for
outbound IP routing. For more information, see Dial Plan File on page 779.
User Info The User Information file maps PBX extensions to IP numbers. The file can be
used to represent PBX extensions as IP phones in the global 'IP world'. For
more information, see User Information File on page 787.
AMD Sensitivity Answer Machine Detector (AMD) Sensitivity file containing the AMD
Sensitivity suites. For more information, see AMD Sensitivity File on page
795.
48.1 Loading Auxiliary Files
You can load Auxiliary files to the device using one of the following methods:

Web interface - see Loading Auxiliary Files through Web Interface on page 772

CLI - see Loading Auxiliary Files through CLI on page 773

TFTP - see Loading Auxiliary Files through ini File using TFTP

EMS (Software Manager) – refer to the EMS User’s Manual
Note:
•
You can automatically load Auxiliary files from a remote server using the device's
Automatic Update mechanism (see Automatic Update Mechanism).
•
Saving Auxiliary files to flash memory may disrupt traffic on the device. To avoid
this, disable all traffic on the device by performing a graceful lock as described in
Locking and Unlocking the Device on page 760.