AudioCodes Mediant 500 E-SBC, User Manual

Page: 726 / 920

User's Manual 726 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
The valid range is any value from 0. The default is 200.
Timeout To Relatch SRTP
[TimeoutToRelatchSRTPMsec] Defines a period (msec) during which if no packets are received
from the current SRTP session, the channel can re-latch onto
another stream.
The valid range is any value from 0. The default is 200.
Timeout To Relatch Silence
[TimeoutToRelatchSilenceMsec] Defines a period (msec) during which if no packets are received
from the current RTP/SRTP session and the channel is in silence
mode, the channel can re-latch onto another stream.
The valid range is any value from 0. The default is 200.
Timeout To Relatch RTCP
[TimeoutToRelatchRTCPMsec] Defines a period (msec) during which if no packets are received
from the current RTCP session, the channel can re-latch onto
another RTCP stream.
The valid range is any value from 0. The default is 10,000.
Fax Relay Rx/Tx Timeout
[FaxRelayTimeoutSec] Defines a period (sec) during which if no T.38 packets are received
or sent from the current T.38 fax relay session, the channel can re-
latch onto another stream.
The valid range is 0 to 255. The default is 10.
54.4.2 HTTPS Parameters
The Secure Hypertext Transport Protocol (HTTPS) parameters are described in the table
below.
Table 54-23: HTTPS Parameters
Parameter Description
Web: Secured Web Connection
(HTTPS)
EMS: HTTPS Only
CLI: secured-connection
[HTTPSOnly]
Determines the protocol used to access the Web interface.

[0] HTTP and HTTPS (default).

[1] HTTPs Only = Unencrypted HTTP packets are blocked.
Note: For this parameter to take effect, a device reset is
required.
EMS: HTTPS Port
CLI: https-port
[HTTPSPort]
Defines the local Secured HTTPS port of the device. This
parameter allows secure remote device Web management from
the LAN. To enable secure Web management from the LAN,
configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply within
this range). The default port is 443.
Note: For this parameter to take effect, a device reset is
required.
Web/EMS: HTTPS Cipher String
CLI: https-cipher-string
[HTTPSCipherString]
Defines the Cipher string for HTTPS (in OpenSSL cipher list
format). For the valid range values, refer to URL
http://www.openssl.org/docs/apps/ciphers.html .
The default is ‘RC4:EXP’ (Export encryption algorithms). For
example, use ‘ALL’ for all ciphers suites (e.g., for ARIA
encryption for TLS). The only ciphers available are RC4 and
DES, and the cipher bit strength is limited to 56 bits.
Note s :

For this parameter to take effect, a device reset is required.