AudioCodes Mediant 500 E-SBC, User Manual

Page: 717 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 717 Mediant 500 E-SBC
Parameter Description
Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For a description of this table, see ''Configuring Test Call Endpoints'' on
page
675 .
54.3.3 Syslog, CDR and Debug Parameters
The Syslog, CDR and debug parameters are described in the table below.
Table 54-19: Syslog, CDR and Debug Parameters
Parameter Description
Web: Enable Syslog
EMS: Syslog enable
CLI: syslog
[EnableSyslog]
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.

[0] Disable (default)

[1] Enable
Notes:

If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).

Syslog messages may increase the network traffic.

To configure Syslog SIP message logging levels, use the
GwDebugLevel parameter.

By default, logs are also sent to the RS-232 serial port. For how to
establish serial communication with the device, refer to the
Installation Manual.
Web/EMS: Syslog Server IP
Address
CLI: syslog-ip
[SyslogServerIP]
Defines the IP address (in dotted-decimal notation) of the computer
on which the Syslog server is running. The Syslog server is an
application designed to collect the logs and error messages
generated by the device.
The default IP address is 0.0.0.0.
Web: Syslog Server Port
EMS: Syslog Server Port
Number
CLI: syslog-port
[SyslogServerPort]
Defines the UDP port of the Syslog server.
The valid range is 0 to 65,535. The default port is 514.
Web: CDR Server IP Address
EMS: IP Address of CDR
Server
CLI: cdr-srvr-ip-adrr
[CDRSyslogServerIP]
Defines the destination IP address to where CDR logs are sent.
The default value is a null string, which causes CDR messages to be
sent with all Syslog messages to the Syslog server.
Notes:

The CDR messages are sent to UDP port 514 (default Syslog
port).

This mechanism is active only when Syslog is enabled (i.e., the
parameter EnableSyslog is set to 1).
Web/EMS: CDR Report Level
CLI: cdr-report-level
[CDRReportLevel]
Enables media and signaling-related CDRs to be sent to a Syslog
server and determines the call stage at which they are sent.

[0] None = (Default) CDRs are not used.

[1] End Call = CDR is sent to the Syslog server at the end of each