CHAPTER 60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter
Description
■
[1]
Enable
Note:
For the parameter to take effect, a device reset is
required.
'Core Dump Destination IP'
[CoreDumpDestIP]
Defines the IP address of the remote server where you
want the device to send the Core Dump file.
By default, no IP address is defined.
'Call Flow Report Mode'
call-flow-report
[CallFlowReportMode]
Enables the device to send SIP call messages to OVOC
so that OVOC can display SIP call dialog sessions as SIP
call flow diagrams.
■
[0]
Disable
(default)
■
[1]
Enable
For more information, see
Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table 60-19:RAI Parameters
Parameter
Description
[EnableRAI]
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured
by the RAIHighThreshold parameter. When enabled and the threshold
is crossed, the device sends the SNMP trap,
acBoardCallResourcesAlarm.
■
[0] = (Default) Disable
■
[1] = Enable
Note:
For the parameter to take effect, a device reset is required.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active
(busy endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note:
The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints.
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this
low threshold, the device sends an SNMP
acBoardCallResourcesAlarm alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically
checks call resource availability.
The valid range is 1 to 200. The default is 10.
- 900 -
Summary of Contents for Mediant 4000 SBC
