AudioCodes Mediant 4000 SBC, User Manual

Page: 253 / 1037

CHAPTER 16 Services
Mediant 4000 SBC | User's Manual
Configuring LDAP Servers
The LDAP Servers table lets you configure up to 500 LDAP servers. The table defines the address
and connectivity settings of the LDAP server. The LDAP server can be configured for SIP-related
queries (e.g., routing and manipulation) or LDAP-based management user login authentication and
authorization (username-password).
The following procedure describes how to configure an LDAP server through the Web interface.
You can also configure it through ini file [LdapConfiguration] or CLI (
configure system >
ldap ldap-configuration
).
When you configure an LDAP server, you need to assign it an LDAP Server Group.
Therefore, before you can configure an LDAP server in the table, you must first
configure at least one LDAP Server Group in the LDAP Server Groups table (see
Configuring LDAP Server Groups ).
➢
To configure an LDAP server:
1. Open the LDAP Servers table ( Setup menu > IP Network tab > RADIUS & LDAP folder >
LDAP Servers ).
2. Click New ; the following dialog box appears:
3. Configure an LDAP server according to the parameters described in the table below.
4. Click Apply .
Table 16-9: LDAP Servers Table Parameter Descriptions
Parameter Description
General
'Index'
[LdapConfiguration_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
'LDAP Servers Group'
server-group
[LdapConfiguration_Group]
Assigns the LDAP server to an LDAP Server Group,
configured in the LDAP Server Groups table (see
Configuring LDAP Server Groups ).
Note:
■ The parameter is mandatory and must be set before
configuring the other parameters in the table.
■ Up to two LDAP servers can be assigned to the
same LDAP Server Group.
- 220 -