AudioCodes Mediant 4000 E-SBC, Configuration Note

Page: 11 / 20

Configuration Note 2. Restoring Defaults using CLI
Version 6.4 11 May 2012
2.2.2 MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant
3000
For the MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant 3000 devices ,
follow the procedure below.

To restore factory defaults:
1. At the CLI prompt, type the following command to access the configuration mode, and
then press the Enter key:
# conf
2. At the prompt, type the following command to reset the device to default settings, and
then press the Enter key:
# RestoreFactorySettings
The CLI commands mentioned in the procedure are shown in the terminal emulation
program (HyperTerminal) below:
Figure 2-2: CLI for Resetting Device to Default (Non-MSBG Devices)