AudioCodes Mediant 3000, User Manual

Page: 304 / 872

User's Manual 304 Document #: LTRT-89729
Mediant 3000

To configure BITS reference clock source redundancy:

In the System Timing page, set the 'TDM Bus Enable Fallback' parameter
(TDMBusEnableFallback) to one of the following:
•
Auto Non-Revertive - enables non-revertive clock fallback between BITS
interfaces.
•
Auto Revertive - enables auto-revertive clock fallback between BITS interfaces.
Notes:
•
BITS synchronization is applicable only when the device's hardware
supports BITS capability.
•
For a full description of the BITS parameters, see 'PSTN Parameters' on
page
766 .
21.2.4.3 Configuring Internal Clock as Clock Source
This section describes how to configure the device to use its internal clock source. The
internal clock source is a stratum 4E-compliant clock source. When the device has no line
interfaces, the device should be configured in this mode.

To configure internal clock as clock source:
1. Set the clock source to be from the device's internal oscillator. In the System Timing
page, set the 'TDM Bus Clock Source' parameter (TDMBusClockSource) to
Internal .
2. For E1/T1 trunks only, set the line to drive the clock on all trunks: In the Trunk Settings
page, set the 'Clock Master' parameter (ClockMaster) to
Generated (for all trunks).
3. If the device has BITS capability, then in the System Timing page, set the 'Timing
Module Mode' parameter (TMMode) to StandAlone (default).
21.3 Configuring Transmission Settings
The Transmission Settings page allows you to define the PSTN transmission type (i.e.,
T3/DS3 or SONET/SDH). For a description of the parameters related to transmission type,
see 'PSTN Parameters' on page
766 .
Notes:
•
Transmission settings are applicable only to Mediant 3000 with TP-6310.
•
When applying your settings, traffic disturbances may be experienced.