AudioCodes Mediant 2000, User Manual

Page: 54 / 418

SIP User's Manual 54 Document #: LTRT-68808
Mediant 2000
Notes:
•
Once you access the 'Multiple Interface Table' page, the 'IP Settings'
page is no longer available.
•
You can view all added IP interfaces that are currently active, in the 'IP
Active Interfaces' page (refer to ''Viewing Active IP Interfaces'' on page
244 ).
•
You can also configure this table using the
ini
file table parameter
InterfaceTable (refer to ''Networking Parameters'' on page 260 ).
¾
To configure the multiple IP interface table, take these 7 steps:
1.
Open the 'IP Settings' page (refer to ''Configuring the IP Settings'' on page 50 ).
2.
Under the Multiple Interface Settings group, click the right-arrow button alongside
Multiple Interface Table
; a confirmation message box appears:
Figure 3-34: Confirmation Message for Accessing the Multiple Interface Table
3.
Click
OK
to confirm; the 'Multiple Interface Table' page appears:
Figure 3-35: Interface Table Page
4.
In the 'Add' field, enter the desired index number for the new interface, and then click
Add
; the index row is added to the table.
5.
Configure the interface according to the table below.
6.
Click the
Apply
button; the interface is immediately applied to the device.
7.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 230 .