AudioCodes Mediant 2000, User Manual

Page: 38 / 418

SIP User's Manual 38 Document #: LTRT-68808
Mediant 2000
•
Edit the Step Name:
a.
In the Navigation tree, select the required Step.
b.
In the 'Step Name' field, modify the Step name.
c.
In the page, click
Next
.
•
Edit the Scenario Name:
a.
In the 'Scenario Name' field, edit the Scenario name.
b.
In the displayed page, click
Next
.
•
Remove a Step:
a.
In the Navigation tree, select the required Step; the corresponding page
opens in the Work pane.
b.
In the page, clear all the check boxes corresponding to the parameters.
c.
Click
Next
.
5.
After clicking
Next
, a message box appears notifying you of the change. Click
OK
.
6.
Click
Save & Finish
; a message box appears informing you that the Scenario has
been successfully modified. The Scenario mode is exited and the menus of the
Configuration
tab appear in the Navigation tree.
3.3.5.4 Saving a Scenario to a PC
You can save a Scenario to a PC (as a
dat
file). This is especially useful when requiring
more than one Scenario to represent different environment setups (e.g., where one
includes PBX interoperability and another not). Once you create a Scenario and save it to
your PC, you can then keep on saving modifications to it under different Scenario file
names. When you require a specific network environment setup, you can simply load the
suitable Scenario file from your PC (refer to ''Loading a Scenario to the Device'' on page
39 ).
¾
To save a Scenario to a PC, take these 5 steps:
1.
On the Navigation bar, click the
Scenarios
tab; the Scenario appears in the Navigation
tree.
2.
Click the
Get/Send Scenario File
button (located at the bottom of the Navigation tree);
the 'Scenario File' page appears, as shown below:
Figure 3-18: Scenario File Page