Survivable Branch Appliance
AudioCodes Enhanced Media Gateway
48
Document #: LTRT-18206
3.
Access the device's Web interface:
a.
Open a standard Web browser application and in the Uniform Resource Locator (URL)
field, enter the device's default IP address (e.g., http://10.1.10.10); the Web interface's
'Enter Network Password' dialog box appears, as shown in the figure below
:
Figure
3-9: Enter Network Password Screen
b.
Enter the device's default login, case-sensitive user name ('Admin') and password
('Admin'), and then click
OK
; the Web interface is accessed, displaying the Web
interface's 'Home' page.
4.
Change the device's IP address, by performing the following:
a.
Open the ‘Multiple Interface Table’ page, (
Configuration
tab >
Network Settings
menu
>
IP Settings
).
b.
Define the device's IP address, subnet mask, and default Gateway IP address (for
“OAMP + Media + Control” application type) so that they correspond to your network IP
scheme.
c.
Click
Apply
.
d.
Save your settings to the flash memory and reset the device.
5.
When implementing a device with two modules, repeat steps 2 through 3 for the second
module; otherwise, skip to Step 6.
6.
Disconnect your PC from the device or from the hub/switch (depending on the connection
method used in Step 1).
7.
Reconnect the device and PC (if necessary) to the network.
8.
Restore your PC’s IP address and subnet mask to their original settings. If necessary, restart
your PC and re-access the device via the Web interface with its newly assigned IP address.
