AudioCodes Media Pack MP-11x, User Manual

Page: 89 / 650

Version 6.6 89 MP-11x & MP-124
User's Manual 6. SNMP-Based Management
6.2 Configuring SNMP Trap Destinations
The SNMP Trap Destinations page allows you to configure up to five SNMP trap
managers. You can associate a trap destination with SNMPv2 users and specific SNMPv3
users. Associating a trap destination with SNMPv3 users sends encrypted and
authenticated traps to the SNMPv3 destination. By default, traps are sent unencrypted
using SNMPv2.

To configure SNMP trap destinations:
1. Open the SNMP Trap Destinations page ( Configuration tab > System menu >
Management submenu > SNMP > SNMP Trap Destinations ).
Figure 6-1: SNMP Trap Destinations Page
2. Configure the SNMP trap manager parameters according to the table below.
3. Select the check box corresponding to the SNMP Manager that you wish to enable.
4. Click Submit to apply your changes.
Note: Only row entries whose corresponding check boxes are selected are applied
when clicking Submit ; otherwise, settings revert to their defaults.
Table 6-2: SNMP Trap Destinations Parameters Description
Parameter Description
Web: SNMP Manager
[SNMPManagerIsUsed_x]
Enables the SNMP Manager to receive traps and checks
the validity of the configured destination (IP address and
port number).

[0] (check box cleared) = (Default) Disables SNMP
Manager

[1] (check box selected) = Enables SNMP Manager
Web: IP Address
[SNMPManagerTableIP_x]
Defines the IP address (in dotted-decimal notation, e.g.,
108.10.1.255) of the remote host used as the SNMP
Manager. The device sends SNMP traps to this IP
address.
Trap Port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.