AudioCodes Media Pack MP-11x, User Manual

Page: 81 / 650

Version 6.6 81 MP-11x & MP-124
User's Manual 5. CLI-Based Management
5.4 Command Shell
The Command Shell interface is used mainly to display current configuration and
performance.
5.4.1 Getting Familiar with the Command Shell
This section provides a description on how to work with the CLI. This includes basic
navigation commands and accessing subdirectories.
5.4.1.1 Basic Command Shell Commands
The table below describes the commands for navigating the Command Shell interface:
Table 5-1: Basic CLI Commands
Purpose Commands Description
Help h Displays the help for a specific command, action, or
parameter.
Navigation cd Enters another directory.
cd root Returns you to the root directory "/>".
.. Goes up one level.
exit Terminates the CLI session.
5.4.1.2 Accessing Subdirectories
The Command Shell commands are organized in subdirectories. When you establish a CLI
session, you are located in the root directory, indicated by the following prompt:
/>
To access a subdirectory, type its name, and then press Enter. For example, to enter the
MGmt subdirectory, type the following:
/>MGmt
Instead of typing the full name of the subdirectory, you can simply type its abbreviated
format. The abbreviated format is shown in upper case (i.e., capital letters). For example,
for the
MGmt subdirectory, you can simply type the following:
/>MG
If you know the full path to a command inside one of the subdirectories, the short format
can be used to run it directly. For example, to run the
PERFormance command in the
MGmt subdirectory, type the following:
/>MG/PERF
Note: The subdirectory names and commands are case-insensitive. For example, it
does not matter whether you type "MGmt" or "mgmt".