AudioCodes Media Pack MP-11x, User Manual

Page: 608 / 650

User's Manual 608 Document #: LTRT-65432
MP-11x & MP-124
44.11.7 Tone Parameters
This subsection describes the device's tone parameters.
44.11.7.1 Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Table 44-54: Tone Parameters
Parameter Description
Web: SIP Hold Behavior
[SIPHoldBehavior]
Enables the device to handle incoming re-INVITE messages
with the "a=sendonly" attribute in the SDP, in the same way
as if an "a=inactive" is received in the SDP. When enabled,
the device plays a held tone to the Tel phone and responds
with a SIP 200 OK containing the "a=recvonly" attribute in the
SDP.

[0] Disable (default)

[1] Enable
Web/EMS: Dial Tone Duration [sec]
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is played.
FXS interfaces play the dial tone after the phone is picked up
(off-hook). FXO interfaces play the dial tone after the port is
seized in response to ringing (from PBX/PSTN).
The valid range is 0 to 60. The default time is 16.
Notes:

During play of dial tone, the device waits for DTMF digits.

This parameter is not applicable when Automatic Dialing is
enabled.
Web/EMS: Stutter Tone Duration
[StutterToneDuration]
Defines the duration (in msec) of the confirmation tone. A
stutter tone is played (instead of a regular dial tone) when a
Message Waiting Indication (MWI) is received. The stutter
tone is composed of a confirmation tone (Tone Type #8),
which is played for the defined duration (StutterToneDuration)
followed by a stutter dial tone (Tone Type #15). Both these
tones are defined in the CPT file.
The range is 1,000 to 60,000. The default is 2,000 (i.e., 2
seconds).
Notes:

This parameter is applicable only to FXS interfaces.

If you want to configure the duration of the confirmation
tone to longer than 16 seconds, you must increase the
value of the parameter TimeForDialTone accordingly.

The MWI tone takes precedence over the call forwarding
reminder tone. For more information on MWI, see
Message Waiting Indication on page
287 .