AudioCodes Media Pack MP-11x, User Manual

Page: 600 / 650

User's Manual 600 Document #: LTRT-65432
MP-11x & MP-124
Parameter Description
[MLPPFlashOverRTPDSCP] The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Web/EMS: RTP DSCP for MLPP
Flash-Override-Override
[MLPPFlashOverOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
44.11.5.9 Call Cut-Through Parameters
The call cut-through parameters are described in the table below.
Table 44-50: Call Cut-Through Parameters
Parameter Description
Web: Enable Calls Cut
Through
EMS: Cut Through
[CutThrough]
Enables FXS endpoints to receive incoming IP calls while the port is in off-
hook state.

[0] Disable (default)

[1] Enable
If enabled, the FXS interface answers the call and 'cuts through' the voice
channel if there is no other active call on the port, even if the port is in off-
hook state.
When the call is terminated (by the remote IP party), the device plays a
reorder tone for a user-defined time (configured by the
CutThroughTimeForReorderTone parameter) and is then ready to answer
the next incoming call without on-hooking the phone.
The waiting call is automatically answered by the device when the current
call is terminated (configured by setting the parameter EnableCallWaiting
to 1).
Note:

This feature is applicable only to FXS interfaces.

You can also configure the feature using an IP Profile
(TelProfile_IP2TelCutThroughCallBehavior):

[0] NO cut through, no paging = Disabled

[1] cutThrough = Channel Cut-Through enabled. When the IP side
ends the call, the device can play a reorder tone to the Tel side for
a user-defined duration (configured by the
CutThroughTimeForReorderTone parameter). Once the tone stops
playing, the FXS phone is ready to automatically answer another
incoming IP call, while in off-hook state.

[2] cutT paging = Channel Cut-Through enabled and no
tones are played.
44.11.5.10 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.