AudioCodes 320HD, Administrator'S Manual

Page: 87 / 116

Administrator's Manual 4. Configuration File-based Management
Version 1.4.1 87 February 2011
4.2.6.7 Dialing Parameters
Table 4-23: Dialing Configuration File Parameters
Parameter Description
voip/dialing/timeout The duration (in seconds) of allowed inactivity between dialed digits. When
you work with a proxy, the number you have dialed before the dialing process
has timed out is sent to the proxy as the user ID to be called. This is useful for
calling a remote party without creating a speed dial entry (assuming the
remote party is registered with the proxy).
The valid range is 0 to 10. The default value is 5.
voip/dialing/phone_num
ber_max_size The maximum length of shortcut numbers that you can enter and the
maximum number of digits that you can dial
The valid range is 0 to 32. The default value is 19.
voip/dialing/dial_comple
te_key/enabled Enables the feature for defining a key to indicate that dialing has completed.
Pressing the Dialing Complete key (defined below) forces the phone to make
a call to the dialled digits even if there is no match in the dial plan or digit map.
ƒ
[0] Disable
ƒ
[1] Enable (default)
Note : This parameter is available only if the parameter
voip/dialing/dial_complete_key/enabled is set to 1.
voip/dialing/dial_comple
te_key/key Defines the Dialing Complete key.
The valid value is a single character. The default value is the pound (#) key.
voip/dialing/dialtone_tim
eout The maximum duration of the dial tone (in seconds) after which the dial tone
stops and a reorder tone is played.
The valid range is 0 to 300. The default value is 30.
voip/dialing/warning_ton
e_timeout The maximum duration of the reorder tone (in seconds) after which the
reorder tone stops and a howler tone is played.
The valid range is 0 to 300. The default value is 40.
voip/dialing/unanswered
_call_timeout Timeout before the phone automatically sends a Cancel message. When the
phone makes a call and the other side doesn’t answer, the phone sends a
Cancel after this timeout
The valid range is 0 to 300. The default value is 60.
voip/dialing/offhook_ton
e_timeout The duration (in seconds) of the howler tone. If the limit is exceeded, the
howler tone stops. The howler tone indicates that the phone has been left in
an off-hook state.
The valid range is 0 to 300. The default value is 120.
voip/dialing/secondary_
dial_tone/enabled
Enables the secondary dial tone.
ƒ
[0] Disable - Phone doesn't use secondary dial tone.
ƒ
[1] Enable (default) - Phone plays secondary dial tone if the secondary dial
tone key is pressed (first digit).
voip/dialing/secondary_
dial_tone/key_sequence
Secondary dial tone is played if this is the first key pressed.
The valid range is 0 to 9. The default value is 9.
Note : This parameter is available only if the parameter
voip/dialing/secondary_dial_tone/enabled is set to 1.