16
Using the product
Turning the low-cut ON/OFF
Specify whether or not to remove low frequencies from the audio signal.
1. Select "LOW CUT."
• The SIG/PK·LOW CUT LED lights.
2. Press the INPUT SEL button to switch the low-cut between ON
and OFF.
• The INPUT SEL LED lights when the low-cut setting is turned on, and it
turns off when the low-cut setting is turned off.
Turning the priority ON/OFF
Set the channel priority. The priority can be set only when SmartMixer is
turned on, and gate mode is selected.
3. Select "PRIORITY."
• The SIG/PK·PRIORITY LED lights.
4. Press the INPUT SEL button to switch the priority between ON
and OFF.
• The INPUT SEL LED lights when the priority is turned on. The INPUT SEL
LED turns off when the priority is turned off.
Turning SmartMixer enable/disable
Switch SmartMixer between enable/disable.
Set SmartMixer mode (gate mode or gain sharing mode) via Web
Remote (p. 52).
1. Select "SMART MIX."
• The SIG/PK·SMART MIX LED lights.
2. Press the INPUT SEL button to switch the SmartMixer between
enable/disable.
• INPUT SEL LED lit:
The SmartMixer is turned enable and the audio of that channel is mixed in
gate mode or gain sharing mode.
• INPUT SEL LED off:
The SmartMixer is turned disable.
Setting the bus assignment
Assign and confirm the output bus for an input channel.
1. Select "ASSIGN."
• The SIG/PK·AEC LED lights.
2. Press the OUTPUT SEL button to select the output bus to be
assigned and confirmed.
• The INPUT SEL LED lights when the channel is assigned to the selected
output bus. The INPUT SEL LED turns off when the channel is not
assigned.
• Press the INPUT SEL button to switch the bus assignment.
INPUT SEL LED lit:
Assigned to an output bus. Audio signals not processed by SmartMixer are
output even when SmartMixer is turned ON.
INPUT SEL LED blinking:
Assigned to an output bus. Audio signals processed by SmartMixer are
output when SmartMixer is turned ON.
INPUT SEL LED off:
Not assigned to any output bus.
Turning the AEC ON/OFF
Turn on/off the AEC (Acoustic Echo Canceler).
1. Select "AEC."
• The SIG/PK·AEC LED lights.
2. Press the INPUT SEL button to switch the AEC between ON and
OFF.
• The INPUT SEL LED lights when the AEC is turned on, and it turns off
when the AEC is turned off.
• Press the INPUT SEL button for the input channel ST to switch the AEC
mode.
INPUT SEL LED of the input channel ST lit: AEC with NC
INPUT SEL LED of the input channel ST blinking: Noise Canceling
INPUT SEL LED of the input channel ST off: OFF
Changing the IP config mode (Auto/Static)
Specify how to obtain the IP address.
1. Press the power button.
• The PRESET LED becomes lit.
2. When the PRESET LED starts blinking, press down the MODE
button, the INPUT SEL button for INPUT channel 4 and the
OUTPUT SEL button.
3. When the LEVEL LED becomes lit, release the MODE button, the
INPUT SEL button for INPUT channel 4, and the OUTPUT SEL
button.
4. The volume LED lights according to the IP Config Mode setting.
5. Turn the dial button and change the IP Config Mode.
6. Restart the product.
Auto
Static
