LCD-9151-201-x Installation Manual
Document # 540334, Rev IR1, 10/2006
Page 13 of 20
3.7.2 Wiring description for the SP-LCD6 is as follows:
SP-LCD6
Pin #
Description
1
+ 28 VDC Power Input
2 Power
Ground
3
Serial Data Bus A (HI)
4
Serial Data Bus B (LO)
5
Serial Data Bus Shield
6
Unit ID 0
7
Unit ID 1
8
Unit ID 2
9
Unit ID Common
3.8
SP-LCD6 Configuration Overview
Configuration is typically accomplished via an SP-LCD6 attached to the
D-Subminiature connector on the monitor. Audio International reserves
the right to add, delete, or alter functions from the setup menus without
advance notification to the user. To access the Main Menu, press the
“MENU 1” button, which will cause the Monitor setup menu to be
displayed on the LCD-9151-201-x. To scroll through the setup modes,
press the “MENU 2” button to scroll forward or the “MENU1” button to
scroll back. When in the desired mode for setup monitor, press either
LEFT (-) or RIGHT (+) to change the selected value. Pressing the LEFT
button decreases the selected value and pressing the RIGHT button
increases the selected value. Press the appropriate button for the desired
adjustment. Press the “MENU 2” button to scroll to the next menu option.