Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.72
Car cover: renewing according to man‐
ufacturer's instructions
Procedure:
– Remove car cover.
– Cover vehicle with a new car cover according to manufactur‐
er's instructions.
3.73
Paintwork, trims, side windows and wip‐
er blades: checking cleanliness
Procedure:
– Check that exterior paintwork, trims, side windows and wiper
blades are clean.
– Clean any dirty components.
3.74
Body: checking vehicle paintwork for
damage and corrosion from below and
with front lid, rear lid and doors open
Procedure:
– Open all vehicle doors, front lid and engine lid.
– Check vehicle paintwork on inside and outside of body for
damage and corrosion.
– Rectify defects of any kind (repair measure).
3.75
Vehicles parked outdoors: locking
Procedure:
– Use vehicle key to lock vehicle if it is parked outdoors.
3.76
Vehicles parked outdoors: covering un‐
protected vehicles with protective trans‐
port film and car cover (not for vehicles
with control number 5K0 on data sticker
on windscreen)
Procedure:
– Apply protective transport film.
– Cover vehicle with car cover.
Note
Do not apply protective transport film to vehicles with PR number
“5K0” on the windscreen; these have been ordered intentionally
without film.
3.77
Road test
Procedure:
– The following points must be checked during the road test:
♦ Engine: performance, misfiring, idling speed, acceleration,
starting behaviour (engine cold and warm), engine noise
Audi R8 2015 ➤
Maintenance - Edition 03.2016
68
3. Maintenance
