Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.67
Vehicle doors: removing edge protec‐
tion
Procedure:
– Carefully remove edge protection from all vehicle doors.
3.68
Vehicle exterior: checking unprotected
areas for dirt, and cleaning if necessary
Procedure:
– Check unprotected areas of vehicle exterior not covered by
car cover or protective transport film for dirt/soiling.
– Clean any dirty areas.
3.69
Vehicle exterior: removing protective
film
Procedure:
– Remove protective film carefully and completely.
3.70
Protective transport film and car cover:
checking position and correcting if nec‐
essary
Procedure:
– Check, and if necessary, correct position of car cover on ve‐
hicle body.
– Check, and if necessary, correct position of protective trans‐
port film.
3.71
Protective transport film: renewing ac‐
cording to manufacturer's instructions
Procedure:
– Go to “http://www.tesa.com/extranet” and log in using the fol‐
lowing details:
♦ Login / E-mail: Bodyguard 50530
♦ Password: PflegeVW
– Order protective transport film, adding the following note:
♦ For Audi vehicles
♦ Ordering number: APS 277 140 (1400 mm)
– Apply new protective transport film according to manufactur‐
er's instructions.
Note
♦
Do not apply protective transport film to vehicles with PR num‐
ber “5K0” on the windscreen; these have been ordered inten‐
tionally without film.
♦
On vehicles with a fabric convertible roof, do not remove the
protective transport covering put in place at the factory.
Audi R8 2015 ➤
Maintenance - Edition 03.2016
3. Maintenance
67
