RECEIVING AND STORAGE
MVE User Manual (710-17074-00G) |
11
5.
Receiving and Storage
5.1
Receiving
Inspect equipment as soon as possible for any damage that may have occurred during transit. Before accepting delivery, examine
packaging for any signs of damage. A damaged package may indicate that the panel and internal components may also be
damaged.
Check that the shipping manifest accounts for all equipment delivered. Any missing or damaged equipment should be noted on
the freight bill and the carrier notified immediately. A record of the missing or damaged equipment should also be sent to AuCom.
NOTE
Avoid using heavy or sharp-edged tools while unpacking, as these may damage the equipment. Use nail pliers to
separate all four sides of the wooden packaging box.
5.2
Storage
If immediate installation is not possible, the equipment should be stored in its original packaging in a clean and dry area indoors.
Always store panels upright on their wooden pallets to keep them off the floor and allow air to pass under it freely.
NOTE
Equipment can be stored for a maximum of 12 months from the date of packaging as the quality of the packaging
material degrades over time.
The following storage conditions should be met:
Temperature
- 25 ˚C to + 70 ˚C
Relative humidity
5% ~ 95%
Rate of change of temperature
0.5 °C/min
STORAGE
The MVE must be stored in its original packaging in a clean and dry environment. The MVE should be unpacked only
after the equipment room is ready for installation. Particular care should be taken to avoid exposure of the electronics
to cement and/or concrete dust.
