PROGRAMMING MENU
10.
Programming Menu
You can access the Programming Menu at any time, including while the soft starter is running. Any changes to the start profile take
effect immediately.
The Programming Menu contains four sub-menus:
Quick Setup
Quick Setup guides you through the parameters required to configure the EMX3 for common
applications. Quick Setup suggests a value for each parameter, but you can change these as required.
Standard Menu
The Standard Menu provides access to commonly used parameters, allowing you to configure the EMX3
to suit your application.
Extended Menu
The Extended Menu provides access to all the EMX3's programmable parameters, allowing experienced
users to take advantage of advanced features.
Load/Save Settings
Load/Save Settings lets you save the current parameter settings to a file, load parameters from a
previously saved file, or reset all parameters to default values.
10.1
Programming Menu
The Programming Menu lets you view and change programmable parameters that control how the EMX3 operates.
To open the Programming Menu, press the MENU button while viewing the monitoring screens.
To navigate through the Programming Menu:
•
to scroll through parameter groups, press the
or
button.
•
to open a submenu, press the button.
•
to view the parameters in a group, press the button.
•
to return to the previous level, press the button.
•
to close the Programming Menu, press repeatedly.
To change a parameter value:
•
scroll to the appropriate parameter in the Programming Menu and press to enter edit mode.
•
to alter the parameter setting, use the
and
buttons. Pressing or
once will increase or decrease the
value by one unit. If the button is held for longer than five seconds, the value will increase or decrease at a faster rate.
•
to save changes, press STORE. The setting shown on the display will be saved and the keypad will return to the
parameter list.
•
to cancel changes, press EXIT. The keypad will ask for confirmation, then return to the parameter list without saving
changes.
10.2
Adjustment Lock
You can lock the Programming Menu to prevent users from altering parameter settings. The adjustment lock can be turned on and
off using parameter 15B.
To lock the programming menu:
1.
Open the Programming Menu.
2.
Open the Extended Menu.
3.
Select 'Advanced'.
4.
Enter the Access Code.
5.
Select parameter 15B
Adjustment Lock
6.
Select and store 'Read Only'.
If a user attempts to change a parameter value when the adjustment lock is active, an error message is displayed:
Access Denied
Adj Lock is On
38
| User Manual (710-04840-00M)
