User manual
– SYSTOE
14 168
Rev. G
Page 18/38
The examination automatically stops when the pressure reaches 10
mmHg. But, if the backflow is clear, it is possible to stop the exam before.
The return of the blood flow takes place when the pressure in the cuff is
lower than the systolic pressure. This is shown on the SysToe by
a clear
and confirmed increase of the sensor signal.
STOP: Manual STOP of the examination
procedure.
Use this function to stop the examination
procedure before the occlusion cuff is fully
deflated if you have noticed the backflow
return or if you are under the impression that
something is wrong.
8.7
Display of the systolic pressure and TBI
Once the examination is over, the following screen is displayed.
The
SysToe
places automatically the vertical cursor. It must be placed at
the foot of the increase of the sensor signal (as on the left hand display).
If it is the case, the user has to press on VALID.
If it is not the case, the user has to move the vertical cursor to its proper
position with the horizontal arrows and then press on VALID
.
VALID: validation of the vertical cursor position and go to the result page.
: Displacement of the vertical cursor.
: Change the displacement speed for cursor scrolling
: Fast scrolling
: Zoom IN/OUT
Vertical cursor
