CHAPTER 5: THE GUI
5-8
DigiVu
®
Series Multichannel MPEG-2/H.264 Encoder/Multiplexer with QAM &/or IP Output - Installation & Operation Manual
5.7 Factory Default IP Address Settings
The GUI is web based and will require a locally connected computer to complete the configuration. The network port through
which access to the web server is available has been factory pre-configured with the following network settings. By default,
the IP address mode is static IP; DHCP is disabled.
FYI:
When entering the default IP address of the DigiVu in a web browser, always be sure to
enter
192.168.0.23/site
or
xxx.xxx.xxx.xxx/site
replacing your unit’s IP address in place of the x’s
Factory Default IP Addresses
IP Address
192.168.0.23
Subnet Mask
255.255.255.0
Web Server Port
80
Gateway
192.168.0.1
5.8 Default Username and Password
Factory Default Username & Password
Username
Password
atx
atx
FYI:
If the DigiVu equipment has previously been configured with a different Username and
Password, use the appropriate values for this unit. When the Username and Password are changed
in the unit, the factory default values are lost. Contact ATX Technical Support for reverting
username/password to default values.
5.9 Resetting the Username and Password
If the Username or Password have been changed and subsequently forgotten, a firmware reset file is available which can
workaround this problem without loss of programmed configuration. Contact ATX Networks for assistance then see
Username & Password Reset Process” on page 12-8
for a description of the process.
