Standards and Compliances
The equipment described in this manual generates and uses radio frequency energy. If this equipment is not used in strict accordance
with the manufacturer's instruction, it can and may cause interference with radio and television reception.
Regulatory Notices
FCC Notices (US only)
Class B - FC 3162, FC 3322, FC 2082, FC 2162, NT 2102, NS 3252, NS 3102, N3 3102, SH 3128
Class A - NQ 3402
This equipment has been tested and found to comply with the limits for a Class B (Class A) digital Adapter, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment under FCC
rules.
Compliance with ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
*Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada
Compliance with EN Regulations
Marking by the symbol
indicates compliance of this ATTO Adapter to the EMC Directive and the Low
Voltage Directive of the European Union.
ATTO ThunderLink Adapters comply with Directive 2011/65/EU, (EU) 2015/863 on the Restriction of the Use of
Hazardous Substances in Electrical and Electronic Equipment (RoHS) and take the following exemptions:
5 - Lead in glass of cathode ray tubes, electronic components and fluorescent tubes.
7a - Lead in high melting temperature type solders (i.e. lead based alloys containing 85% by weight or more lead).
7c-I - Lead in electronic ceramic parts (e.g. piezoelectronic Adapters)
13 - Lead and cadmium in optical and filter glass
The product has been certified and bears the Mark, as applicable, of the EMC and Product Safety authorities as
indicated below:
