ATTO Technology FastStream NDMP 4600, Installation And Operation Manual

Page: 48 / 58

41
ATTO Technology Inc. FastStream Installation and Operation Manual
5.1.9 NDMP commands
If your FastStream NDMP 4600 has been configured for NDMP, default settings to the two FastStream
NDMP 4600 Ethernet data ports may be customized to your specifications using the CLI commands in
this section.
NDMPAuthType
Controls the security level used by the FastStream NDMP
4600 for NDMP authentication for all ports.
Default: none
set NDMPAuthType [none | text | md5]
Requires a SaveConfiguration command
get NDMPAuthType
NDMPMaxVersion
Controls the highest NDMP version to which the
FastStream NDMP 4600 negotiates for each Ethernet
data port.
Default: 4
set NDMPMaxVersion [DPn | all] [3 | 4]
Requires a SaveConfiguration command
get NDMPMaxVersion
NDMPPortNumber
Controls the NDMP port number that to be used by the
FastStream NDMP 4600 for each Ethernet data port.
Default: 10000
set NDMPPortNumber [DPn | all] [port number]
Requires a SaveConfiguration command
get NDMPPortNumber
NDMPStatus
Shows status of all NDMP servers, including mover
servers. The server name is not mutually exclusive, i.e.,
the same server name may apply to a mover and
tape/SCSI service at the same time.
ServerName - Device connection name
Port - Ethernet port number [0|1]
Type - tape, mover, SCSI
Host - IP address of host connection
State - [idle | listen | active | paused | halted]
NDMPStatus