Thank you for purchasing your new solar powered attic vent from
Attic Breeze
. Our attic vents have
been carefully designed to provide easy installation with minimal tools or experience required.
Before beginning installation of your new attic vent, please read through this guide and review
the tools required for installation. If you do not have the needed tools or feel uncomfortable
performing any of the tasks required for installation, contractor services are available in most
areas to assist you with your installation needs.
Please note that this guide is intended for informational purposes only.
Attic Breeze
assumes
no responsibility for any damages incurred during or as a result of installation of our products.
Step 1 - Ventilation Requirements:
For proper function of your solar attic vent, your home
must have the minimum required amount of outside air intake available to the attic space.
This is typically accomplished through either soffits or gable vents.
Attic Breeze
recommends
a minimum of 750 square inches of net free area intake ventilation per an installed unit. All
attic intake vents should be clean (no debris) to allow for free movement of outside air into the
attic space.
YOU MUST HAVE THE REQUIRED AMOUNT OF INTAKE VENTILATION AREA TO
ACHIEVE PROPER ATTIC VENTILATION.
If your attic does not have adequate ventilation,
you should add enough soffits or gable vents to meet the minimum recommended intake
ventilation area.
FAILURE TO MEET THESE REQUIREMENTS MAY RESULT IN POOR
PERFORMANCE OF YOUR ATTIC VENT AND/OR ATTIC DEPRESSURIZATION.
4582 Kingwood Drive
Suite E-154
Kingwood, TX 77345
877-288-4234
www.atticbreeze.net
Curb-Mounted Attic Fan Installation Guide
1
Attic Vent Housing with Attached
20-watt or 25-watt Solar Panel and
Thermal Switch.
Parts List
Models 203A/204A/253A/254A
Models 203D/204D/253D/254D
1
Attic Vent Housing with Attached
Thermal Switch.
1
20-watt or 25-watt Solar Panel with
15 feet of UV Resistant Wiring.
1
Mounting Bracket Kit
Tools Required
Extension Ladder
Reciprocating Saw
Power Drill with Nut/Screw Driver and
½ inch Bit
Electrical Tape
Self-Tapping Roofing Screws
Caulking Gun with Water Proof
Roofing Sealant
Measuring Tape or Ruler
String and Permanent Marker
Flashing for Curb Box
8 foot weather treated 2x4 Stud
Installation Instructions
