ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 93 / 366

Installation
SuperTrak™ GEN3 System Operation and Maintenance Manual 81
Rev. 9 (12-2021)
Install a SuperTrak Conveyance Platform Section on a
SuperTrak GEN3 Frame
This section describes how to install a straight or curved on a SuperTrak GEN3
frame.
Install a Straight Section on a SuperTrak GEN3 Frame
1. Install the two (2) cross-braces on top of the frame:
a. Align a cross-brace with the frame
holes.
b. Align a dowel pin with the cross-
brace positioning hole. Make sure
the threaded end is up.
c. Use a mallet to tap the dowel pin
through the cross-brace hole and
into the frame. The top of the
dowel pin is slightly under the
cross-brace surface when installed
correctly.
Always use appropriate lifting devices (for example, a forklift or crane)
and use safe lifting practices and procedures when lifting a straight or
curved section.
See
Lift a SuperTrak Conveyance Platform Section on page 74.
ATS recommends that you obtain relevant information from your national
Health and Safety Authority.