ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 259 / 366

Maintenance
SuperTrak™ GEN3 System Operation and Maintenance Manual 247
Rev. 9 (12-2021)
Cleaning Procedures
This section describes SuperTrak conveyance platform cleaning procedures.
Clean the SuperTrak Conveyance Platform
Remove Dust and Dirt
1. Wipe with a soft damp cloth to remove dust and dirt.
2. Wipe with a mild detergent on a soft cloth.
3. Wipe with a damp soft cloth to remove detergent.
4. Dry with a clean soft cloth or chamois.
Remove Wet Paint, or Grease
1. Wipe with a clean soft cloth dampened with isopropyl alcohol or equivalent.
2. Dry with a clean soft cloth or chamois.
Clean a Control Panel Air Filter
Air filters are located on the side of the control panel.
1. Carefully remove the front plastic filter support.
2. Gently peel back the sponge filter.
3. Use a vacuum to carefully remove any particulate from the filter unit.
4. Replace the filter.
5. Snap the filter cover back into position over the filter.
After cleaning the SuperTrak conveyance platform frame, clean up all
spills and excess water immediately. Liquid on floors causes a slip hazard.
Never use razor blades, scrapers, squeegees, brushes or any other
abrasive tools to clean the SuperTrak conveyance platform frame. Use of
these tools may cause damage.