ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 226 / 366

214 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Install a Station Setup Fixture
Install a station setup fixture when station tooling alignment verification is
required.
1. Position a pallet below a station setup
stationary mount.
2. Place the station setup removable locate
over the pallet.
3. Tighten the two (2) top thumb screws to
secure the station setup removable locate
to the station setup stationary mount.
4. Lightly tighten the side thumb screw to
lock the pallet in position against the
datum. The side thumb screw has an integrated slip clutch to prevent over-
tightening.
Remove a Station Setup Fixture
1. Loosen the side thumb screw.
2. Loosen the two (2) top thumb screws.
3. Lift the station setup removable locate straight up, to remove it from the pallet.
4. As required, complete one of the following procedures:
• Store the station setup removable locate in a safe place for future use.
• Turn the station setup removable locate around, so the side thumb
screw is on the inside of the SuperTrak conveyance platform, and then
tighten the two (2) top thumb screws to secure it in position for future
use.
• Improper use of a station setup fixture may cause damage to the
pallets or tools.
• Do not move or adjust a station setup fixture without the assistance
of a trained technician.
• Remove all removable locating plates before operating the SuperTrak
conveyance platform.
A
Station setup stationary mount
B
Top thumb screw (1 of 2)
C
Station setup removable locate
D
Side thumb screw