ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 223 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 211
Rev. 9 (12-2021)
6. Position a new lubrication felt into the lubrication holder.
Make sure the V-groove of the lubrication felt aligns with the V-groove of the
lubrication holder.
7. Install one (1) screw in the back of the lubrication holder and into the
lubrication felt.
8. Insert the lubrication holder into the pallet.
Make sure the V-groove of the lubrication Felt is horizontal with the pallet V-
wheels.
9. Install the lubrication locking block over the base of the lubrication holder.
10. Secure the lubrication locking block in position with two (2) screws.
11. Lubricate the lubrication felt.
See Lubricate the Pallet Lubrication Felt on page 250.
Replace a Pallet Spring
1. Complete steps 1 to 4 of Replace a Pallet Lubrication Felt on page 210.
2. Remove the spring.
3. Position a new spring into the pallet.
4. Complete steps 6 to 10 of Replace a
Pallet Lubrication Felt on page 210.