3-58
Maximus Reference Manual
MANU-MAXIMUS-02
Revision-02
Test Mode
Chapter 3: Monochrome Terminals
Use the following procedure to run the GSM Signal Strength test:
1. In the
Test Mode
menu, press the
clear
key until the
GSM Signal
Strength
option appears.
2. Press the enter key to start the test. The display shows a numerical
strength value on the left and a graphical representation of the
strength to the right.
3.
If desired, you can press the
enter
key to return to the GSM Signal Strength
parameter (then press it again to restart the test).
4.
Press the
clear
key to exit to the
Test Mode
menu when finished.
DIDO Test 1
The DIDO test checks the functionality of the Data-In-Data-Out port on the terminal (also
referred to as the Auxiliary Port). This test requires specific loopback “jumper” and is typically
only performed by an ATS service technician. It’s noted here for reference purposes.
1.
Insert the “loopback jumper” into the DIDO port on the terminal.
2.
In the
Test Mode
menu, press the
clear
key until the
Test DIDO 1
option
appears.
Test Mode
GSM Signal Strength
GSM Signal Strength
15 | oooooooo_ _ _ _ _ |
Test Mode
DIDO Test 1
