ATS 2140-M Series, Instruction Manual

Page: 75 / 115

75
7.4 Testing
Once the test specification and specimen have been created, testing can begin. Before beginning any
test, ensure that:
1. All setup procedures outlined in Section 6 have been completed.
2. The frames have been properly balanced.
3. A specimen is installed in the frame with the thermocouples properly attached. Refer to 8.2 for
assistance with proper thermocouple attachment.
4. The drawhead and elevator, if equipped, are positioned properly.
5. Observe all safety precautions.
WARNING: TESTING MAY INVOLVE VERY HIGH FURNACE TEMPERATURES. ENSURE THAT
THE FURNACE IS CLOSED, MATERIALS ARE IN A POSITION TO AVOID A FIRE HAZARD, AND
HIGH TEMPERATURE WARNING NOTICES ARE POSTED TO ALERT PERSONNEL OF POTENTIAL
HAZARDS.
7.4.1 System Status Display
The System Status Display is the main display used by the operator during normal operation of the
system. Machine states and alarm conditions are displayed on the status display screen.
Refer to Appendix B for a complete list of the display headings, colors, and alarm codes.
7.4.2 Starting a Test
The general procedure to start a test is to select an idle frame, install the specimen in the frame, and tell
the system to start testing the specimen. There are four ways to begin this procedure, and the method
chosen is based on operator preference.
1. Balance the lever arm with the upper load train installed completely to the specimen.
NOTE: There should be no load weights on the weight pan at this time.
2. Install all upper load train components and specimen per test requirements.
NOTE: The hot coupling, hot stud, alignment coupling, etc. are all part of the upper load train.
3. If an extensometer is used, install the upper crosshead and gauging platform assembly to the
specimen.