ATS 2140-M Series, Instruction Manual

Page: 7 / 115

7
Section 1: Introduction
1.1 General Description
The Applied Test Systems (ATS) WinCCS system combines proprietary hardware and software with a
direct load or lever arm tester to provide computer automation of the entire test process. Using archived
test specifications, the system will:
control furnace temperature •
apply the appropriate load •
collect creep, load, and temperature data
•
archive test results in a logical format.
•
Constant stress and stress relaxation testing is accommodated on some models . The system is supplied
with new ATS frames as well as retrofitted into existing frames made by ATS and other manufacturers.
SERIES
2140 2320 2330 2410 2430 2510
MM X X X X X X
MS X X X X X X
CCM X NA X X X X
CCS X NA X X X X
SRM NA NA X NA NA NA
SRS NA NA X NA NA NA
X This model fits this category.
NA Not applicable on this model.
MM WinCCS Modular Controls Main Tester
MS WinCCS Modular Controls Secondary Tester
CCM WinCCS Classic Controls Main Tester
CCS
WinCCS Classic Controls Secondary Tester
SRM WinCCS Classic Controls Main Tester with Stress Relaxation Capabilities
SRS
WinCCS Classic Controls Secondary Tester with Stress Relaxation Capabilities
NOTE: All Secondary Testers (Modular and Classic) must be paired with a Main Tester.
NOTE: Only one Secondary Tester can be connected to a Main Tester.