Atrust t68WD, User Manual, Page: 53 / 140

Configuring Client Settings
Configuring System Settings
43
3. Type in the desired description for the snapshot.
4. Click to check
Deployment
as the snapshot type and then click
Apply
.
5. A message appears prompting for confirmation. Click
Yes
to confirm.
6. The system will restart to complete the process automatically .
NOTE
• Please wait for the process to complete
automatically
. Taking a snapshot needs
several minutes and requires system reboot more than one time. In addition,
the Sysprep process will not be shown on the desktop but only be performed
in the background.
4.2.7 Deploying a System Image with a Created Snapshot
Your snapshots may be stored on a remote computer over the network or on a USB flash drive. Depending on where
your snapshot is located, you can deploy a system image either through a network or a USB flash drive.
NOTE
• For detailed information on how to take a snapshot, please refer to section “4.2.6
Taking Snapshots for Mass Deployment” on page 42.
With a Snapshot on a Remote Computer
To deploy a system image on your t68WD with a snapshot on a remote computer, please do the following:
1. On Atrust Client Setup, click System > Firmware Update .