Industrial PoE Injector with DC voltage booster
IJG7001 Series
Version 1.0
Updated in October, 2019
P/N : 89900568G
Inside the package you will find the following items:
■ Inject x 1
■ Installation Guide with Warranty Card x 1
Front View
IJG7001
Never install or work on electrical or cabling during periods of lightning activity.
Never connect or disconnect power when hazardous gases are present.
Warning:Hot Surface Do Not Touch. RESTRICTED ACCESS AREA: The equipment
should only be installed in a Restricted Access Area.
Indoor
Indoor
This equipment should be installed indoor and not connect directly with equipment
installed outdoor.
1. PWR1 LED
2. PWR2 LED
3. PoE LED
4. 10/100/1000 BASE-T(X) RJ45 Port
5. 10/100/1000 BASE-T(X) RJ45 PoE RJ-45 Port
6. DIP Switch
1. Grounding Screw
2. Terminal for Power 2
3. Terminal for Power 1
4. Frame Ground
P1
P2
PoE
PoE out
Data in
1
2
3
6
5
4
1
2
3
4
V2+
V1+
F.G.
1
2
1
2
You can then choose whether to plug in the other peripheral ports at this point
or do it later depending on the actual location of the device or level of comfort
for performing such operation.
3.
Once the plate has been firmly put in place, proceed to mount the whole
device as shown in (Fig. 3).Proceed to (Fig. 4) if you want to remove the
device from DIN-Rail.
4.
Next we can then proceed to connect
the device to the LAN (switch or PC,
depending on the case), take care on
using the RJ-45 connector; after this
we can then proceed to the device’s
settings
5.
If you have purchased the wall mount kit,
proceed to place the screws on the back
of the device as show in (Fig. 1).
1.
2.
Although internal grounding has been
done inside, in order to ensure overall
maximum performance and protect your
device, it is still strongly advised to ground
the device properly; hazardous ESD can
come into contact and damage your
equipment. On the power terminal block,
there is a terminal for Frame Ground, you
can choose whether to connect it to the
grounding or you may opt to connect to
the grounding screw next to the terminal
block ( the one chosen should be connect-
ed at all times ) (Fig. 2)
■ The opening to the sides are for the
device’s heat dissipation please never
obstruct or cover them with any
objects or try to insert them through it.
V2+
V1+
F.G.
V2+
V1+
F.G.
