8
First Steps
Aton CLT300 - Gig S455 / swisscom-en / Internet / starting.fm / 23.04.2007
¤
Insert a fingernail into the headset
socket cavity and pull the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base with its
display facing upwards
.
The handset registers automatically. Reg-
istration can take up to 5 minutes. During
this time
Regstr.Procedure
appears in the
display and the name of the base station
flashes, e.g.
Base 1
. The handset will be
assigned the lowest unassigned internal
number (1–6).
This will appear in the display when regis-
tration is complete, e.g.
INT 1
. This means
that the number 1 has been assigned. If
the internal numbers 1–6 are already
assigned to other units, the number 6 is
overwritten.
To charge the batteries, leave the handset
in the base station.
For questions and problems see page 52.
Headset socket
You can connect the following types of
headset (with jack connector): HAMA
Plantronics M40, MX100, MX150 and the
supplied headset.
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon
e
in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged
and
discharged.
¤
To do this, leave the handset in the
base or charging cradle
continuously
for
ten
hours. Your handset need not
be switched on for it to charge.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully dis-
charged.
Please remember:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and re-
insert them.
Notes:
– Automatic registration is only possible
while no-one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
– You can change the name of the handset
Notes:
– If the handset has switched itself off
because the batteries are flat and is then
placed in the base station, it will switch
itself on automatically.
– Only place the handset in the base or
charging cradle that is intended for it.
Note:
After the first battery charge
and
discharge
you may replace your handset in its base after
every call.
