ATOMSTACK Befon A5 Pro Plus, Manual

Page: 3 / 33

Shenzhen AtomStack Technologies Co., Ltd. support@atomstack3d.com
0. Security Statement
Before Using the laser engraving, please read this safety guide
carefully, it mentions situations that require special attention and includes
warnings of unsafe practices that can cause damage to your property or
even endanger your personal safety.
0. 1 Laser safety
Befon A5 PRO+ uses Type 4 laser product. The lasers are very
powerful that can cause eye injuries and burn the skin.
We have installed a laser cover on the laser. To a large extent, the
shield filters out the diffuse light from the laser spot. However, it is still
recommended to wear laser goggles when using the laser engraver.
Avoid exposing your skin to Type 4 laser beams, especially at close
range.
Teens must be supervised by parents while using the machine.
Do not touch the laser engraving module while it is switched on.
0.2 Fire safety
The high intensity laser beam generates extremely high temperatures
and a lot of heat due to it burns the substrate when it cuts.
Some materials can catch fire during the cutting process, then
creating gas and smoke inside the equipment.
When the laser beam hits the material, Usually, there will be a small
flame. It will move with the laser and will not remain lit as the laser passes
over it.
Do not leave the machine alone during the engraving process.
Please do remember to clean the laser cutter of debris, scraps and
flammable materials after use.
Always keep a working fire extinguisher nearby.
Safety against fumes or airborne contaminants
When using a laser engraver, fumes, vapors, particles are generated
from the material (plastics and other flammable materials), there are
potentially toxic . These fumes or airborne contaminants can be hazardous
to health.