
Product range
Code
Colour temperature
Finish
AT9032/WH/WW
Warm white
White
AT9032/WH/CW
Cool white
White
AT9032/WH/DL
Daylight
White
10W LED Plastic trim downlight with dimmable driver.
INSTALLATION SHEET
LED DOWNLIGHT
AT9032
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and
electronic equipment should never be disposed of with general household waste but must be separated of it’s correct
SAFETY INFORMATION
• Luminaires must be installed and fitted by a qualified
electrician ensuring the installation complies to the current
wiring regulations.
• Ensure all electrical connections are secure and that there are
no loose strands.
• Do not install this product on damp or newly plastered ceilings.
• Always ensure there is adequate ventilation around the driver
at all times.
Ø110mm
Ø90mm
31.5mm
Product specification
Voltage
230V~ 50Hz
Power consumption
10W
Light colour options
Warm white Cool white Daylight
Lumen output
800lm
830lm
850lm
Colour temperature
3000K
4000K
5000K
Colour rendering index
>80
Beam angle
90
°
Dimmable
Yes
Warranty
3 Years
Working temperature
50°C
IP Rating
IP44
IC Rating
IC-4
Electrical classification
Class II
Max. daily usage
TBA
Installation
Read instructions and check you have all the tools and accessories to
complete the installation correctly.
1. A. Isolate the mains power supply before commencing installation.
B. Cut
Ø
90mm hole in desired position.
2. Feed mains cable through cut-out and plug into mains supply.
3. Connect fitting to LED driver.
4. Fold spring clips and push into cut-out.
5. Downlight fully installed into ceiling cut-out.
6. Restore mains power.
1
Isolate mains power.
B
A
Cut hole in the desired position.
2
3
Feed mains cable
through cut-out and
plug into mains supply.
4
Fold back spring clips and push into cut-out.
5
Downlight fully installed into ceiling cut-out.
6
Restore mains power.
Click
Connect fitting to LED Driver.