Product range
Code
Colour temperature
Finish
AT9025/AND/CW
Cool white
Anodised
AT9025/AND/WW
Warm white
Anodised
AT9025/WH/CW
Cool white
White
AT9025/WH/WW
Warm white
White
3W LED Shelf light
INSTALLATION SHEET
LED DOWNLIGHT
AT9025
Product specification
Voltage
6V
Power consumption
3W
Light colour options
Warm white
Cool white
Lumen output
100lm
130lm
Colour temperature
3000K
4000K
Colour rendering index
>75
Beam angle
45°
Dimmable
No
Warranty
3 Years
Working temperature
40°C
IP Rating
IP20
IC Rating
IC4
Electrical classification
Class III
SAFETY INFORMATION
• Luminaires must be installed and fitted by a qualified
electrician ensuring the installation complies to the current
wiring regulations.
• The LED's in this downlight CANNOT BE REPLACED.
• Ensure all electrical connections are secure and that there are
no loose strands.
• Do not install this product on damp or newly plastered ceilings.
• Always ensure there is adequate ventilation around the driver
at all times.
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and
electronic equipment should never be disposed of with general household waste but must be separated of it’s correct
treatment and recovery. Where possible recycle your packaging. Please keep these instructions safe for future reference.
Installation
Read instructions and check you have all the tools and accessories
to complete the installation correctly. This product is dimmable with
standard "Triac Dimmers". It is recommended that you only use the
endorsed dimmer brands. Please consult your lighting provider before
installation.
1. A. Isolate the mains power supply before commencing installation.
B. Cut
Ø
45mm hole in desired position.
2. Feed mains cable through cut-out and connect to compatible driver.
3. Fold spring clips and push into cut-out.
4. Fit downlight into ceiling cut-out.
5. Ensure correct lighting installation, switch power supply on.
18mm
Ø52mm
Ø45mm
B
A
3
5
Isolate mains power
Feed mains cable through cut-out
and connect to compatible driver
Fully located into cut-out
Fold spring clips and push into
cut-out
1
2
4
Cut hole in the desired position
Restore mains power
